Ford diagnostic test procedure symbols how to#
Ford diagnostic test procedure symbols software#
Ford diagnostic test procedure symbols code#

However, sometimes the error codes occur from a random failure and thereРІР‚в„ўs nothing to fix. If you havenРІР‚в„ўt fixed the issues, the same codes might come back immediately. Only after fixing, you should proceed to resetting the check engine light. You should investigate the codes and fix the issues causing the errors. Most of the time the diagnostic trouble codes appear for a good reason. This way you can save the diagnostic information for later analysis. While in the Trouble Codes tab, tap the share button from the top header and select the preferred method. You can also export all the codes and the freeze frame.

Change the tab in the top to switch the view between confirmed, pending and permanent DTCs and freeze frame.

Ford diagnostic test procedure symbols software#

The software will read and show the information. To read the DTCs with the desktop software, navigate to Trouble Codes from the left navigation panel.Otherwise, proceed to the step B for mobile app (Android or iOS) usage. If you are using the desktop version (PC, Mac or Linux), continue with the step A. Refer to the connection instructions of the platform and dongle.

It also depends on the connection method (Bluetooth, WiFi or USB). The connection procedure is a bit different depending on the platform you are using. Now, launch the OBD Auto Doctor car diagnostic software and connect to the dongle. If the dongle has on/off switch, make sure it is turned on. If the dongle has some LEDs, they should start blinking. DonРІР‚в„ўt start the engine because to reset the light, the engine shouldnРІР‚в„ўt be running. Make sure the adapter is tightly attached but donРІР‚в„ўt use too much force. Typical place for the socket is the compartment under the driverРІР‚в„ўs side dashboard.Р”В¬onnect the OBD2 dongle to the connector. The connector should be located close to the steering wheel. Search for 16-pin D-shaped connector that will match the adapter. Locate the OBD-II diagnostic connector in your car. The codes help you identify the issue and determine the cause. The DTCs will tell you the reason for the fault. Reading the diagnostic trouble codes (DTCs) is an important step to start with.

Ford diagnostic test procedure symbols how to#

This tutorial will show you how to read the diagnostic trouble codes and reset the Check Engine Light yourself.

Ford diagnostic test procedure symbols code#

When the vehicle detects an issue, it will set an active trouble code and trigger the CEL. There is always at least one OBD2 diagnostic trouble code associated with the check engine light. Ignoring the warning can cause serious damage to the car. This warning light is the main indicator to warn you about problems with the vehicle. The indicator light is sometimes also referred as Malfunction Indicator Light (MIL). This malfunction is indicated by triggering the Check Engine Light (CEL). Either the engine is having a problem or the emission control system has detected an issue. The Check Engine Light indicates that there is a problem with the car.